Filter
Top Products
Command ASCII command
(host to processor)
Response
(processor to host)
Additional description
Output Configuration
Output scaler rate
Set output rate
EX2!RATE} RateX2!]
Select output resolution and refresh
rate.
View output rate
ERATE} X2!]
Show selected output rate.
Digital output format
Set format
EX@*X4*OTYP} OtypX@*X4**X4(]
Sets the output color space/format for
digital output to X4*. Automatic format
X4( is also reported in the response.
View setting
EX@OTYP} X4**X4(]
View the output color space for digital
output X@. Automatic format X4( is
also reported in the response.
Screen saver (runs when no active video in selected input)
Set mode
EMX4)SSAV} SsavMX4)] Sets the screen saver mode to X4)
(default: 1 = black).
View mode
EMSSAV} X4)]
View the current screen saver mode
X4).
Set time duration
ETX2*SSAV} SsavTX2*]
Sets the screen saver time duration
X2* seconds (default: 501 = never).
View time duration
ETSSAV} X2*]
View the screen saver time duration
X2*.
View screen saver status
ESSSAV} X6#] View screen saver status X6#.
NOTE: When the Screen Saver mode automatically enables or disables output sync (entering or exiting
the X6# = 2 state), an unsolicited SsavS X6# ] response is broadcast.
AFL mode
Disable AFL mode
E0GLOK} Glok0]
Disables global AFL mode (default).
Enable AFL mode
E1GLOK} Glok1]
Locks the outputs refresh rate to the
inputs refresh rate.
View AFL mode setting
EGLOK} X1)]
View current global AFL mode
DTP protocol
View protocol
EO3HDBT} X7$]
View twisted pair output protocol
NOTE: An unsolicited “HdbtO3* X7$] is broadcast to all verbose 1 or 3 ports if the position of the DTP/
HDBaseT switch is changed.
NOTE: X@ = Output selection: 0 = All outputs (Only available for Video Mute),1 = Output 1 Only (HDMI),
2 = Output 2A Only (HDMI), 3 = Output 2B Only
X1)
= 0 (off/disable), 1 (on/enable)
X2! = Scaler resolution; see page 41 for scaler resolution details
X2* = On-screen menu time-out (default = 10) /Output sync time-out (default = 501-never)
0 = Menu/cursor never times out/output sync is instantly disabled with no active input
1 to 500, in 1 second increments, 501 = output sync never times out
X4) = Screen Saver modes; 1 = Black screen (Default), 2 = Blue output with OSD “INPUT x NO SIGNAL”
X4* = HDMI Output Format; see page 43 for HDMI output formats
X4( = Digital Output Format: see page 43 for Digital output formats
X6# = Screen Saver Status; 0 = Active Input; timer not running, 1 = No active input; timer is running;
output sync still active, 2 = No active input; timer has expired; output sync disabled
X7$ = DTP Output Format; 0 = DTP format (Default), 1 = HDBaseT Format
Annotator 300 • SIS Communication and Control 45