Filter
Top Products
Command/Response Table for IP SIS Commands
Command ASCII (Telnet)
(host to processor)
URL Encoded (Web)
(host to processor)
Response
(processor to host)
NOTE: A user password cannot be assigned if an administrator password does not exist. Entering a password when the Annotator 300 has not been configured
yields an E14 response from the processor. If the administrator password is cleared (removed), the user password is also removed.
Read administrator password
ECA} WCA
|
X14!]
Set administrator password
E X13#CA} WX13#CA
|
Ipa•X13#]
Clear administrator
password
E•CA} W%20CA
|
Ipa•]
Set user password
E X13#CU} WX13#CU
|
Ipu•X13#]
NOTE: A user password cannot be assigned if an administrator password does not exist.
Clear user password
E•CU} W%20CU
|
Ipu•]
Read user password
ECU} WCU
|
X14!]
Set verbose mode
E X12@CV} W X12@CV
|
VrbX12@]
NOTE: The processor can send out unsolicited information (such as notice of a volume or input change or a change in some other setting). That is called verbose
(wordy) relationship between the processor and a connected device. For a direct RS-232/422 connection, the processor is set for Verbose mode by default.
When the Annotator 300 is connected via Ethernet, Verbose mode is disabled by default in order to reduce the amount of communication traffic on the network.
If you want to use the Verbose mode with a processor connected via Ethernet, this mode must be set to On each time you reconnect to the processor.
Read verbose mode
ECV} WCV
|
X12@]
NOTE:
X12@
= Verbose mode: 0 = clear/none (default, Telnet), 1 = verbose mode (default, RS-232/RS-422), 2 = tagged responses for queries,
3 = verbose mode/tagged for queries.
X13# = Password (12 characters = maximum length; no special characters are allowed.)
X14!
= Reading Password: RS-232 connection responds with password. IP connection responds with 4 asterisk (****) if password exists and empty if not,
instead of actual password.
Annotator 300 • SIS Communication and Control 60