Filter
Top Products
Using the Menus
To configure the Annotator 300 using any of the menus, do the following:
1. Press the Menu button repeatedly to reach the desired configuration menu.
2. Press the Next button repeatedly to go to the desired submenu.
3. The LCD shows the current values. Observe the LCD and rotate either (or both)
Adjust knob to change the values as desired.
NOTES:
• Pressing the Menu button within any level takes the user back to the current top
level menu.
• When in any menu for approximately 25 seconds and no buttons have been pressed
or Adjust knobs rotated, the unit times out and returns to the default cycle.
User Presets
Within this menu, up to 16 presets can be saved or recalled.
Save a user preset
1. From the default display cycle, press Menu to enter the User Presets submenu.
2. Press Next twice to go to the Save Preset menu.
3. Rotate either front panel Adjust knob ([{) to select a preset
(1 to 16) to save the current settings to. Default setting is <N/A>.
Select <N/A> and press Next to move to the next submenu without saving.
4. Press Next to save the current image settings to the selected preset number.
The Preset is saved and the LCD goes back to the top level User Preset menu.
NOTE: If an existing preset is chosen to save to, the previous settings are overwritten
in favor of the new (current) settings.
Recall a user preset
1. From the default display cycle press Menu to enter the User Presets submenu.
2. Press Next to go to the Recall Preset menu.
3. Rotate either front panel Adjust knob ([{) to select a preset
(1 to 16) to recall as the current settings. Default setting is N/A.
Select <N/A> and press Next to move to the next submenu without recalling.
4. Press the Next button. The preset is recalled, the image changes to the recalled
settings, and the LCD goes back to the top level User Preset menu.
Recall Preset
<02>
Save Preset
<N/A>
Annotator 300 • Operation 17