Filter
Top Products
200 Chapter 17 Adding or replacing a cooling fan
P0609324 01
5 Remove the snap rivets that hold the fan to the BCM1000. Refer to Figure 106 and Figure 107.
6 Lift the old fan out of the BCM1000.
Figure 106 Removing the fan (BCM1000 version 2.5 single-fan model)
Figure 107 Screw attachments beside fan holes (BCM1000 version 2.5 redundant model)
Note: Redundant fans
If the fans are piggy-backed, the back fan connects directly to a power supply connector
through a patch connector.
If the fans are side by side, then both fans are connected on the SSM board. Fan wires run
under the power supply and are connected to J7 or J6 on the SSM board, as shown in
Figure 105.
Fan attachments
Fan attachments