Filter
Top Products
90 Chapter 7 Setting media bay module DIP switches
P0609324 01
Setting the DIP switches on the modules
Before you install the media bay modules into the BCM1000 or BCM1000e housing, you need to
set the DIP switches. Make a note of these settings either on the chart shown in Table 11 on page
88 or in the Programming Record forms.
Follow these steps to set the DIP switches:
1 Locate the DIP switches on the module.
Figure 40 Switches on the media bay module
2 Set the switches to correspond with the settings you chose “Determining module DIP switch
settings” on page 87.
3 Repeat for each media bay module you want to install.
GATM and ASM8+ modules: Set the country settings to either be off, if the country profile
and software version for your system allows firmware downloads, or set the dip switches to
activate the appropriate country settings. Refer to “GATM switch settings” on page 94.
4 You are now ready to install the modules into the BCM1000 or BCM1000e units. Refer to
Chapter 9, “Starting the system,” on page 115 for details.
654321
Off
On
Underside of the
media bay module
DIP switches
Back of the media bay module
123456
On
Off
Back of the media bay module
Module is
right-side up