Filter
Top Products
Chapter 7 Setting media bay module DIP switches 103
Installation and Maintenance Guide
Companion has not be included in this table because you cannot use modules set to double density
to deploy Companion.
Table 24 DSM 16+ and DSM32+ double density switch settings for 2.5 systems upgraded to BCM 3.0 or
newer software
Select
DS30
bus #
Enter these switch
settings
2
To assign these
DNs to
DSM 16+:
(A=DSM1, B=DSM2)
To assign these DNs
to
DSM 32+
(connectors:
A=top,
B=bottom)
2
Custom DN
range
1 2 3 456
02
on on on on on A
221-236
A
377-392
off
on on on on B
377-392
B
221-236
off off
03
on on on on A
237-252
A
393-408
off off
on on on B
393-408
B
237-252
off off off
04
on on on on A
253-268
A
409-424
off off
on on on B
409-424
B
253-268
off off off
05
on on on A
269-284
A
425-440
off off off
on on B
425-440
B
269-284
off off off off
06
on on on on A
285-300
A
441-456
3
off off
on on on B
441-456
3
B
285-300
off off off
07
1
on on on A
301-316
A
457-472
4
off off off
on on B
457-472
4
B
301-316
4
off off off off
1
If your system is configured with a 3/5 split, you cannot use DS30 07 for the DSM 16 module.
2
The extensions listed are based on a three-digit DN with a Start DN of 221. If your system has longer DNs or a
different Start DN, enter the range in the blank column.
3
Available only on systems set to FDD. Modules cannot be set to double density on systems set to PDD. Refer to the
previous chart for the switch settings for single density and PDD.
4
Available only on systems set to FDD, with a 2/6 DS30 split. Modules cannot be set to double density on systems
set to PDD. Refer to the previous chart for the switch settings for single density and PDD.