Filter
Top Products
182 Chapter 16 Replacing the hard disk
P0609324 01
Initializing the hard disk (single-disk system, BCM 3.0)
The BCM1000 is normally initialized at the factory. However, if you have to replace the hard drive
in a single-disk BCM1000, you must re-initialize the Business Communications Manager.
After you replace the hard disk and the system has booted up, perform the initialization as follows:
1 Enter the terminal emulation program, as described in “Finding the configuration menus” on
page 126.
The Platform Initialization Menu appears. Refer to Figure 84.
Figure 86 Platform Initialization Menu screen
2 Enter 1 (Initialize Menu) and press <ENTER>.
The Initialize Menu appears. Refer to Figure 87.