Filter
Top Products
102 Chapter 7 Setting media bay module DIP switches
P0609324 01
Companion can only be deployed on systems that remain at Part Double Density (PDD), the
default condition of BCM 3.0 and newer systems.
02
on on on on on on
221-236
221-252
(DS30 02 and 03)
N/A
03
on on on on on
237-252
237-268
(DS30 03 and 04)
off
04
on on on on on
253-268
253-284)
(DS30 04 and 05)
off
05
on on on on
269-284
269-300
(DS30 05 and 06)
off off
06
on on on on on
285-300
285-316
(DS30 06 and 07)
565-580
3
(PDD only)
off
07
1
on on on on
301-316 N/A
581-596
3
(PDD only)off off
1
If your system is configured with a 3/5 DS30 split, you cannot use DS30 07 for the DSM 16 module. You cannot
configure the DSM 32 module for DS30 06 because the second set of DNs cannot be accessed.
2
The extensions listed are based on a three-digit DN with a Start DN of 221. If your system has longer DNs or a
different Start DN, enter the range in the blank column.
3
If you need more DNs for Companion sets, use the range that starts at 597 (ISDN or DECT) and change the
DN type to Companion. If you system is set to Full Double Density (FDD), Companion telephones are not supported.
Table 23 DSM single density switch settings for new BCM 3.0 (or newer) systems
Selec
t
DS30
bus #
Enter these switch
settings
2
To
assign
these DNs
to
DSM 16
or DSM 16+
To assign these
DNs to DSM 32 or
DSM 32+
Top Bottom
To assign
these DNs to
Companion
2
Custom DN
range
123456
02
on on on on on on
221-236 253-268 221-236
N/A
03
on on on on on
253-268 285-300 253-268
off
04
on on on on on
285-300 317-332 285-300
off
05
on on on on
317-332 349-364 317-332
off off
06
on on on on on
349-364 381-396 349-364
565-580
3
(PDD only)
off
07
1
on on on on
381-396 N/A
581-596
3
(PDD only)
off off
1
If your system is configured with a 3/5 split, you cannot use DS30 07 for the DSM 16 module. You cannot
configure the DSM32 module for DS30 06 because the second set of DNs cannot be accessed.
2
The extensions listed are based on a three-digit DN with a Start DN of 221. If your system has longer DNs or a
different Start DN, enter the range in the blank column.
3
If you need more DNs for Companion sets, use the range that starts at 597 (ISDN or DECT) and change the
DN type to Companion. If you system is set to Full Double Density (FDD), Companion telephones are not
supported.
Table 22 DSM single density settings for BCM 2.5 systems upgraded to BCM 3.0 or newer software