Filter
Top Products
100 Chapter 7 Setting media bay module DIP switches
P0609324 01
ASM8+ country switch settings
The ASM8+ has a second set of eight dip switches on the right side, at the rear of the module, that
allow you to choose a country setting and three modes of function.
• Switch 1: firmware download capability
— off= no firmware downloads (for systems running BCM 3.5 and previous software
— on = allow firmware downloads (for systems running BCM 3.6 and newer software)
• Switch 2: when to download firmware:
— off = download firmware based on version
— on = download firmware at cold start
05
0 on on on on
269-276 317-324
off off
1 on on on
277-284 325-332
off off off
2 on on on
425-432 333-340
off off off
3 on on
433-440 341-348
off off off off
06
0 on on on on on
285-292 349-356
off
1 on on on on
293-300 357-364
off off
2
3
on on on on
441-448 365-372
off off
3
3
on on on
449-456 373-380
off off off
07
1
0 on on on on
301-308 381-388
off off
1 on on on
309-316 389-396
off off off
2
4
on on on
457-454 397-404
off off off
3
4
on on
455-472 405-412
off off off off
1
If your system is configured with a 3/5 split, DS30 07 is not available.
2
The extensions listed are based on a three-digit DN with a Start DN of 221. If your system has longer
DNs or a different Start DN, enter the range in the blank column.
3
Available only on systems set to FDD.
4
Available only on systems set to FDD, with a 2/6 DS30 split.
Table 20 ASM8 settings for upgraded 2.5 systems and new 3.0 systems (Continued)
Select
bus#
Select
offset
Enter these switch
settings
To assign these DNs
2
Custom DN
range
123456
2.5 system
upgraded to 3.0
New 3.0 system