Filter
Top Products
104 Chapter 7 Setting media bay module DIP switches
P0609324 01
Companion has not be included in this table because you cannot use double density modules to
deploy Companion.
Table 25 DSM 16+ and DSM32+ double density switch settings for new systems with BCM 3.0 or newer
software
Select
DS30
bus #
Enter these switch
settings
To assign these
DNs
to
DSM 16+:
A= DSM1, B=DSM2
To assign these DNs to
DSM 32+ (connectors:
A=top, B = bottom)
2
Custom DN
range
12 3456
02
on on on on on A
221-236
A
237-252
off
on on on on B
237-252
B
221-236
off off
03
on on on on A
253-268
A
269-284
off off
on on on B
269-284
B
253-268
off off off
04
on on on on A
285-300
A
301-316
off off
on on on B
301-316
B
285-300
off off off
05
on on on A
317-332
A
333-348
off off off
on on B
333-348
B
317-332
off off off off
06
on on on on A
349-364
A
365-380
3
off off
on on on B
365-380
3
B
349-364
off off off
07
1
on on on A
381-396
A
397-412
4
off off off
on on B
397-412
4
B
381-396
off off off off
2
The extensions listed are based on a three-digit DN with a Start DN of 221. If your system has longer DNs or a
different Start DN, enter the range in the blank column.
1
If your system is configured with a 3/5 split, you cannot use DS30 07.
3
Available only on systems set to FDD. Modules cannot be set to double density on systems set to PDD. Refer to
the previous chart for the switch settings for single density and PDD.
4
Available only on systems set to FDD, with a 2/6 DS30 split. Modules cannot be set to double density on systems
set to PDD. Refer to the previous chart for the switch settings for single density and PDD.