Filter
Top Products
Chapter 16 Replacing the hard disk 189
Installation and Maintenance Guide
Installing the mirrored disk controller
If you upgrade your system from a single-disk system to a mirrored disk system, you will need to
install the RAID board as well as a second hard disk.
The RAID board is installed beside the media bay module housing in the BCM1000. Refer to
Figure 95.
You can upgrade both 2.5 and 2.0 hardware to have mirrored capability. You do not require a
redundant power supply and redundant fans to support this feature. If you are upgrading either
system, you must be running 2.5 FP1 software or higher and have at least 256 RAM of memory
installed. If you need to install more memory, refer to “Replacing memory” on page 223.
Figure 95 Base unit with RAID board, plus redundant power and fans
RAID board
Two hard disks