Filter
Top Products
Manual Setup menuFigure D-7:
Characterize
1 Sensor Type
2 Sensor Tag Parameters
Measurements
1 Flow
2 Density
3 Temperature
4 Update Rate
5 LD Optimization
6 Special Units
7 External Pressure/Temperature
8 Petroleum Measurement *
9 GSV
10 Conc Measure (CM) **
1
2
Inputs/Outputs
1 Channels
2 mA Output
3 Frequency Output
4 Discrete Output
5 Communications
6 Variable Mapping
3
Info Parameters
1 Transmitter Info
2 Sensor Information
Communications
1 HART Address
2 Tag
3 Device Identification
4 Dev ID (CP)
5 Set Up Burst Mode
6 mA Output Mode
7 Set Up RS-485 Port
5
Display
1 Language
2 Display Variable Menu Features
3 Offline Variable Menu Features
4 Backlight
5 Display Variables
6 Decimal Places
4
Transmitter Info
1 Tag
2 Xmtr Serial Num
3 Message
4 Descriptor
5 Date
6 Write Protect
Sensor Information
1 Sensor Type
2 Sensor Serial Num
3 Tube Wetted Mat.
4 Tube Lining
5 Sensor Flange
1
2
On-Line Menu >
2 Configure >
1 Manual Setup
5
* Displayed only if petroleum
measurement is enabled on your
transmitter. Menu numbers are
adjusted as required
.
** Displayed only if concentration
measurement is enabled on your
transmitter.
Using the Field Communicator with the transmitter
328 Micro Motion
®
Model 2700 Transmitters with Analog Outputs