Filter
Top Products
42
Recording/playing back a song
For more on the settings content, refer to “Loop Effect
Parameter Functions” (p. 131).
5. Press CURSOR [ ] [ ] to display the Send Level
settings screen.
When using CHO/DLY
fig.00-441d
When using REV
fig.00-442d
6. Press CURSOR [ ] [ ] and the TIME/VALUE dial to
adjust each track’s send level.
* Pressing a REC TRACK button moves the cursor to the track
corresponding to the button pressed.
Pressing [TRACK] switches to between Tr1–4 and Tr5–8.
The “send level” is the volume level of the signal sent
from each respective track to each effect, and you can
change the amount of effect applied by adjusting the
send level.
The send level for each track is also indicated in the
lower row of the display.
fig.00-443d
7. After you have completed adjusting the send level,
press [EXIT] repeatedly to return to the Play screen
You can switch screens in the following sequence, with
the screen cycling to the next screen each time [LOOP
EFFECTS] is pressed.
Loop Effects selection screen → Send Level screen →
Type screen → Play screen
(
10
) Bounce
(Putting multiple tracks together)
fig.00-444a
1. Press [REC MODE] repeatedly until “BOUNCE” is
indicated for REC MODE at the left of the screen.
fig.00-444d
■ : V-Tracks with recorded data.
❐ : V-Tracks without data.
“What are V-Tracks?” (p. 14)
2. Use CURSOR [ ] [ ] and the TIME/VALUE dial to
select the track/V-track to which you want to record.
3. Press [ENTER].
Return to the Play screen.
fig.00-445d
4. Press [REC].
[REC] flashes in red and the BR-864 enters the recording
standby state.
fig.00-446
Send level of the each tracks
1
456
2
3
2
Flash