Filter
Top Products
25
Listening to the demo songs
Quick Start
* When using the FS-5U foot switch (sold separately), set the
polarity switch as shown below. If the polarity switch is not set
correctly, the foot switch may not operate properly.
fig.00-304
* If using an expression pedal (EV-5 or FV-300L), set the MIN
volume level to “0.”
● Insert the memory card (CompactFlash) with the gold-
colored contacts facing downward (the side without
contacts should be facing upward).
* Carefully insert the memory card all the way in-until it is
firmly in place.
* Do not touch the contacts of the memory card or allow them to
become dirty.
fig.00-305
Before inserting the memory card, be sure to first turn off
the BR-864. If a memory card is inserted when the power
is turned on, the data in the memory card may be
destroyed, or the memory card may become unusable.
(2) Turn on the BR-864
Once the connections have been completed, turn on power to
your various devices in the order specified. By turning on
devices in the wrong order, you risk causing malfunction
and/or damage to speakers and other devices.
1. Before you turn the power on, make sure of the
following points.
❒ Are all external devices connected properly?
❒ Is the volume on the BR-864 and all other devices
completely lowered?
❒ Is the memory card inserted?
* The BR-864 is shipped with a memory card already inserted in
the slot.
2. Lower the MASTER fader on the BR-864.
fig.00-306
3. Turn on the device connected to an input jack (i.e.,
GUITAR/BASS, MIC, or LINE IN).
4. Turn on the POWER switch located on the rear panel.
fig.00-307
* Always make sure to have the volume level turned down before
switching on power. Even with the volume all the way down,
you may still hear some sound when the power is switched on,
but this is normal, and does not indicate a malfunction.
* This unit is equipped with a protection circuit. A brief interval
(a few seconds) after power up is required before the unit will
operate normally.
5. Turn on the device connected to the output jack (i.e.,
LINE OUT or DIGITAL OUT).
If you are using the AC adaptor, make sure that the AC
adaptor does not become unplugged during operation. If
the AC adaptor becomes unplugged accidentally, the
recorded data may become damaged.
Polarity Switch
Play Screen
The Play screen is the most fundamental screen of the
BR-864, and is the first screen that appears when the BR-
864 is turned on (see below).
fig.00-308d