Filter
Top Products
22
Panel Descriptions
5. DIGITAL OUT connector
Optical connector for outputting digital audio signals. The
same sound that is output from LINE OUT is also output
from DIGITAL OUT. You can connect a DAT recorder or CD
recorder to this connector and make digital recordings of the
BR-864’s output.
6. FOOT SW/EXP PEDAL jack
This is an input jack for connecting a separately sold foot
switch (BOSS FS-5U, Roland DP-2) or expression pedal
(BOSS Roland EV-5, BOSS FV-300L).
By using this FOOT SW jack, you can start/stop playback,
punch in/out, and more.
When an expression pedal is used, you can control the depth
of effects with your foot.
“Using a foot switch or expression pedal” (p. 136).
7. MIDI OUT connector
Connector for sending MIDI data.Connect it to the MIDI IN
connector of an external MIDI device (rhythm machine or
sound module).
8. USB connector
This is the connector for connecting your computer to the BR-
864 with a USB cable.
9. POWER switch
This is the power switch. It turns the power of the BR-864
on/off.
10.
DC IN (AC Adaptor) jack
Connect the AC adaptor (PSA-series; optional) to this jack.
You must use only the PSA-series AC adaptor. Use of any
other adaptor may cause overheating or malfunctions.
11.
Cord Hook
Wrap the cable around this hook so that the AC adaptor
cable is not pulled out accidentally.
* If the AC adaptor is disconnected during operation, your
important recorded data may be lost.
12.
Security Slot ( )
http://www.kensington.com/
Inserting batteries
1. Make sure that the power of the BR-864 is turned off.
2. Remove the battery cover on the rear panel.
* When turning the unit upside-down, get a bunch of
newspapers or magazines, and place them under the four
corners or at both ends to prevent damage to the buttons and
controls. Also, you should try to orient the unit so no buttons
or controls get damaged.
* When turning the unit upside-down, handle with care to avoid
dropping it, or allowing it to fall or tip over.
3. Being careful not to reverse the polarity (+/-), insert six
AA dry-cell batteries into the battery compartment.
* BOSS recommends using longer-life alkaline batteries.
* Do not mix new batteries with partially used batteries, and do
not mix batteries of differing types.
* Do not use rechargeable batteries.
4. Close the battery cover.
fig.00-205
When the battery power becomes low, “Battery Low”
appears in the display. When this message appears, replace
the existing batteries with new ones as soon as possible.