Filter
Top Products
40
Recording/playing back a song
3. Adjust the faders so the tracks being played back are at
a suitable level.
4. Press [REC].
[REC] flashes in red and the BR-864 enters the recording
standby state.
5. Press [PLAY].
The [REC] and REC TRACK button indicators change
from flashing in red to being continually lit and
recording begins.
[PLAY] lights up.
Only what you are currently playing is recorded to the
new track. The music that is being played back is not
recorded.
* If you use the INPUT LEVEL knob to turn down the volume
of the input source during recording, the sound will be
recorded in the audio track at a low volume, so that noise will
be more apparent when you raise the volume of the audio track
for playback.If you want to lower the sound of the input source
that you are monitoring, lower the volume with the MASTER
fader.
To change the volume of the music being played back, use the
TRACK fader for the respective tracks.
6. When you finish recording, press [STOP].
* You cannot play back sounds recorded for less than one
second.
(9) Adjusting the sound for
each track
You can adjust the tone, panning, and volume balance for
each track individually.
Setting the positioning (pan) of the sound
1. Press [PAN].
fig.00-434b
The Pan settings screen appears.
fig.00-434d
2. Press CURSOR [ ] [ ] and turn the TIME/VALUE
dial to change each track pan settings.
* Pressing a REC TRACK button moves the cursor to the track
corresponding to the button pressed.
Pressing [TRACK] switches to between Tr1–4 and Tr5–8.
* Pressing [ENTER] sets this to “C00” (Center).
3. Press [PAN] (or [EXIT]) to return to the Play screen.
Adjusting the tone (Track EQ)
“Track EQ” is an independent two-band equalizer featured
on each track that allows you to adjust the high- and low-
frequency tonal qualities separately.
1. Press [EQ].
fig.00-435a
2. Press CURSOR [ ] [ ] and turn the TIME/VALUE
dial to turn each Track EQ on or off.
* Pressing a REC TRACK button moves the cursor to the track
corresponding to the button pressed.
Pressing [TRACK] switches to between Tr1–4 and Tr5–8.
Some tips for overdubbing
When you record new material while listening to a
recorded performance, your playing may tend to be
buried in the existing performances, making it difficult
for you to play. In this case, you can slightly lower the
faders of the playback tracks, or pan the playback tracks
to left (or right) and the sound you are playing to right
(or left) to make it easier to hear yourself.
“Setting the left-right positioning (pan) of the
sound” (p. 40)
“Changing the position of the input sound” (p. 47)