Filter
Top Products
27
Listening to the demo songs
Quick Start
3. Turn the TIME/VALUE dial to select “01:Dreamin’.”
4. Press [ENTER].
■
If you have changed the recording or editing
Since the BR-864 automatically updates the recorded data
and operation content if the recording or editing have been
changed, you do not need to perform any special operations
for saving.
During updating, “Keep power on!” appears in the upper
line of the display, while the lower line shows what is being
processed.
* If you try to record or edit data using a protected demo song,
“Protected!” appears.
Playing Back a Song
1. Move the TRACK faders 1/5–4/8 and the RHYTHM
GUIDE fader to the positions shown in the figure
below, and lower the MASTER fader.
fig.00-315
2. Press [PLAY].
fig.00-316
The song starts. Slowly increase the MASTER fader and
adjust the volume to the desired level.
Use of the demo song supplied with this product for any
purpose other than private, personal enjoyment without
the permission of the copyright holder is prohibited by
law. Additionally, this data must not be copied, nor used
in a secondary copyrighted work without the permission
of the copyright holder.
By adjusting the TRACK faders, you can listen to the
individual sounds recorded to each track one at a time or
listen to them at the balance you desire.
Press [FF] to fast-forward the song and press [REW] to
rewind the song. Press [ZERO] to move to the time
location 00:00:00-00.0.
In addition to the procedures given above, you can also
change your current position in the song using the
procedures given below.
Changing the current position
Elapsed time display
The value given at “TIME” in the display shows the elapsed
time into the song using MTC (MIDI time codes) and is
expressed as follows: hours-minutes-seconds-frames-sub
frames.
The time code specifications can differ depending on the
device. To synchronize operation with another device using
MTC, you will first need to match the time code
specifications of both devices. At the factory settings, one
second is set to 30 frames (non-drop) (p. 142).
Moving to the start of a play
To move to the time where the first sound of a song is
recorded, press and hold [STOP] and press [REW].
Each V-Track of the selected track is checked and you move
to the time of the first recorded sound for the song.
Press [ZERO] to move to the time location 00:00:00-00.0.
Moving to the end of a play
To move to the time where the last sound of a song is
recorded, press and hold [STOP] and press [FF].
Each V-Track of the selected track is checked and you move
to the time of the last recorded sound for the song.
fig.00-317
Title Composer Copyright
Dreamin’ Yutaka Nakano
© 2003, BOSS Corporation
TIME
23:59:59-29.900:00:00-00.0
[
ZERO
]
[
STOP
] + [
REW
]
[
STOP
] + [
FF
]
Section of the song recorded