Filter
Top Products
106
About the drum kits
Start Point (“S”)
Specify the measure or location to be used as the start
point for loading the drum sounds.
fig.03-508d
End Point (“E”)
Specify the measure or location to be used as the end
point for loading the drum sounds.
From the screen for setting the start point, press
CURSOR [ ] repeatedly to display the screen for
setting the end point.
fig.03-509d
You can preview the drum sounds in the specified range
by moving the cursor to “PVW” and pressing [ENTER].
Determine the sounds to load while setting the start and
end points and the length, and repeating the preview.
* You can press [PLAY] to preview the sounds, and press
[STOP] to stop the sounds.
5. When you have finished setting the start and end
points, move the cursor to “LOAD” and press [ENTER].
fig.03-510d
6. Specify the load-destination song drum kit with the
TIME/VALUE dial, then press [ENTER].
S1–5: Song Drum Kit 1–5
fig.03-511d
7. Specify the load-destination drum sound with the
TIME/VALUE dial, then press [ENTER].
The load is executed.
To cancel, press [EXIT].
fig.03-512d
BeatMeasure
FrameHours Minutes Seconds
BeatMeasure
FrameHours Minutes Seconds