Filter
Top Products
5-5
DD
Scope set mode (continued)
5
FUNCTIONS FOR RECEIVE
Turn the transmitting signal waveform indication ON
and OFF.
NOTE: The transmitting signal waveform indica-
tion is available for the center mode only.
Scope during Tx (CENTER Type)
ON
Turn the peak level holding function ON and OFF.
Max Hold
ON
Select the center frequency of the spectrum scope
indication (center mode only).
• Filter center : Shows the selected filter’s center
frequency at the center.
• Carrier Point Center
: Shows the selected operating
mode carrier point frequency at
the center.
• Carrier Point Center (Abs. Freq.)
: In addition to the carrier point
center setting above, the actual
frequency is displayed for the
bottom of the scope.
CENTER Type Display
Filter Center
Set the waveform color for the currently received sig-
nals.
• The color is set in RGB format.
• Push [F-3•Ω≈] to select R (Red), G (Green) and B
(Blue), and rotate the ratio from 0 to 255 range.
• The set color is indicated in the box beside the RGB
scale.
Waveform Color (Current)
0 204 102
Set the waveform color for the receiving signals max-
imum level.
• The color is set in RGB format.
• Push [F-3•Ω≈] to select R (Red), G (Green) and B
(Blue), and rotate the ratio from 0 to 255 range.
• The set color is indicated in the box beside the RGB
scale.
Waveform Color (Max Hold)
0 102 153
Select the sweep speed for the ±2.5 kHz span selec-
tion from SLOW, MID and FAST.
NOTE: The waveform may be displayed incorrect-
ly with “FAST” setting.
Sweep Speed (± 2.5k)
MID
Select the sweep speed for the ±5 kHz span selec-
tion from SLOW, MID and FAST.
NOTE: The waveform may be displayed incorrect-
ly with “FAST” setting.
(± 5k)
MID
Select the sweep speed for the ±10 kHz span selec-
tion from SLOW, MID and FAST.
(± 10k)
FAST