Filter
Top Products
12-9
12
SET MODE
■ ACC set mode (continued)
Selects the transceiver’s reference signal condition
from IN, OFF and OUT.
•IN: Use an external reference signal for the IC-
7700. Turn the transceiver power OFF then
ON to make the setting effective.
• OFF : Not input/output the reference signal.
(default)
• OUT : Outputs the IC-7700 reference signal to ex-
ternally connected equipment(s) for their ref-
erence.
NOTE: If the applied reference signal is off-fre-
quency, or no signal is applied with “IN” selection,
the IC-7700 will not work properly. Select “OFF” or
“OUT” then reboot the IC-7700 in such case.
REF IN/OUT
OFF
Adjusts the internal reference signal frequency within
0 to 100% range in 1% steps during frequency cali-
bration.
NOTE: Default setting is different for each trans-
ceiver.
REF Adjust
50
%
■ Display set mode
Adjusts the LCD unit brightness from 0 (dark) to 100%
(bright) range in 1% steps. (default: 50%)
LCD Unit Bright
50
%
Adjusts the switch indicators brightness from 1 (dark)
to 100 (bright) range in 1 steps. (default: 80)
Backlight (Switches)
80
Selects the desired display type from A (Black back)
and B (Blue back). (default: A)
See p.13-4 for details.
Display Type
A
Selects the desired font for frequency readout from
Basic (1), Basic (2), Italic, Round and Slim.
(default: Basic (1))
See p.13-4 for details.
Display Font
Basic (1)