Filter
Top Products
12-8
12
SET MODE
■ ACC set mode (continued)
Selects the switching relay type for [RELAY] from
Lead and MOSFET.
Select the suitable relay type when connecting a non-
Icom linear amplifier.
• Lead : Use mechanical relay.
(16 V DC/0.5 A max.; default)
• MOS-FET: Use semiconductor type relay.
(250 V/200 mA max.)
SEND Relay Type
Lead
Selects the desired item for an external meter indica-
tion.
• Auto : Outputs the receiving signal strength level
during receive, and outputs the selected
level (selected with [METER]), during
transmit. (default)
•S : Outputs the receiving signal strength level
during receive.
•Po: Outputs the transmitting power level dur-
ing transmit.
• SWR : Outputs the VSWR level during transmit.
• ALC : Outputs the ALC level during transmit.
• COMP : Outputs the compression level during
transmit.
•VD : Outputs the drain terminal voltage of the
final amplifier MOSFETs.
•ID : Outputs the drain current of the final am-
plifier MOSFETs.
External Meter Output
Auto
Sets the output level for an external meter indication
with in 0 to 100% range in 1% steps.
• Approx. 2.5 V at 50% (default) setting for full-scale indica-
tion. (4.7 kΩ impedance)
External Meter Level
50
%
Selects the desired connector(s) for modulation input
when data 3 mode (D3) is in use.
• MIC : Use the signals from [MIC]. (default)
• ACC : Use the signals from [ACC1] (pin 4).
• MIC,ACC : Use the signals from [MIC] and [ACC1]
(pin 4).
• S/P DIF : Use the signals from [S/P DIF].
DATA3 MOD
MIC