A SERVICE OF

logo

Configuration Swap
H−2 CM 4000 Installation and Operating Manual
1. Using the configurations for the Jupiter XPress system, Xpress−1 and Xpress−2 for this document, verify that both
configurations have at least one Jupiter XPress board running VGA. Using the Jupiter Configurator, go to Jupiter >
VGA Status Display:
Figure H−1.
2. Select the CM VGA Options (Jupiter > CM VGA Options) to include in each configuration. All options should be
selected for this procedure.
Figure H−2.
3. Save, compile and download the first configuration (Xpress−1) to the system.
4. Once the system is rebooted and active again, verify the system is operating correctly.
5. While pressing and holding the NEXT button, press and release the UP button on a Jupiter XPress board configured
for VGA to enter the System Command Page.
6. Verify that the Current Configuration for each board is now Xpress−1.