A SERVICE OF

logo

Open as PDF
next previous
Control Panel Operation
CP 3000
6−17CM 4000 Installation and Operating Manual
SEQ — SELECT INPUT SEQUENCES
Special input selection sequences or macros may be defined via the Sequence Set table (Figure 5−80). On the CP 3000
Switcher Control Panel, the SEQUENCE soft−key allows the operator to access these pre−defined sequences.
The operator presses MENU and then the SEQ soft−key to display the first page of sequence names. The operator then presses
the soft−key corresponding to the desired sequence and TAKE.
If entry of a password is requested, please see Passwords on page 6−22.