Configurator
CP Output Set
5−82 CM 4000 Installation and Operating Manual
If you want to use a factory default category set (as shown on pages 5−84 and 5−85), leave the Category Set as “Default.”
If you wish to associate an existing Output Set with a different category set than the one originally assigned, see page
5−105.
6. Click on one of the CP types:
CP310
CP320
CP328
CP2002B
CP3000
CP3008
†
CP3310
CP3800
CP3808
CP3824
CP3830
CP3832
EMEM
MC3020D
†
MC3020L
†
SATRN
†
SERIAL
UMD3A
Create Output Set
Figure 5−66. .
• If CP 2002, CP 3000, or CP 3800 is selected, clicking on “Apply” and “Open Table” will open up a blank
version of the table shown in Figure 5−67. These are 20−category panels. Press the INSERT button to start
building the table. Then skip to Step 9.
• CP 3809 and CP 3810 expansion panels do not have a separate CP Output Set. They use the Output Set as-
signed to the main panel associated with them.
• If CP 320, CP 328, or CP 3808 is selected, clicking “Apply” and “Open Table” will open a blank version of
the table shown in Figure 5−67 . These are 16−category panels. Press the INSERT button to start building the
table. Then skip to Step 10.
• If CP 3824 is selected, clicking “Apply” and “Open Table” will open a blank version of the table shown in
Figure 5−67 . This is a 15−category panel. Press the INSERT button to start building the table. Then skip to
Step 10.
• For CP 3830 panels, select type “CP3830.” Clicking on “Apply” and “Open Table” will open a blank version
of the table shown in Figure 5−67. These are 12−category panels. Press the INSERT button to start building
the table. Then skip to Step 10.
• If CP 310 is selected, clicking on “Apply” and “Open Table” will open a blank version of the table shown in
Figure 5−67. This panel does not use categories or mnemonics, but the table is used to assign the panel’s eight
outputs. Press the INSERT button to start building the table. Then skip to Step 11.
†
Not supported by Jupiter XPress.
