A SERVICE OF

logo

Open as PDF
next previous
Configurator
MPK Devices
5−134 CM 4000 Installation and Operating Manual
Single Bus Status Only (Stand−alone) (“CP−3810L”)
In this mode, the panel is configured to status a single output. No other panel is associated with the panel. and there is no
switcher control. An example entry is shown in Figure 5−117.
MPK bus
CP 3810
“CP3810”
Levels for 1
destination
Figure 5−116.
CM 4000 “CM1”
CP3810 CP−3810L 2 00000044 3832−IN VT01 KXYZ−LEV
1
MPK Devices
MPK
Expansion
Pass
Board
CM1
Port Address Input Sets Output Sets Level Set Overide Set Sequence Set
Devices word
In Panel Out Panel
Figure 5−117.
Device
Type
Select “CP−3810L” as the device Type. In the Output Set column, enter the name of the output to be statused.
For operating instructions, see page 6−126.