A SERVICE OF

logo

Open as PDF
next previous
Configurator
Machine Control Table
5−146 CM 4000 Installation and Operating Manual
DEFAULT (SEMI−PERMANENT) LINKAGE
Using the file server, machines can be linked directly to a specific control panel on a semi−permanent basis. An example sys-
tem is shown in Figure 5−124. In this arrangement, only the file server can re−assign control of a machine to another panel.
In other words, the normal linkage function (where machine control follows the routing switcher) is bypassed. The entries
needed on the Machine Control table are shown in Figure 5−125.
“VT01”
“VC01”
“VC02”
“TAPEMC”
MC−3000
VC02VC01VT01
SELECT buttons
control lines
software links established
by file server
Figure 5−124. Default machine control linkage.
312 6
Serial Ports
CM 4000 System Controller “CM1”
Figure 5−125. Default linkage entries
for system shown in Figure 5−124.
1
Machine Control
Device Name Device Type
Delegation
In/Out
Associated
2
TAPEMC
MC−3000E Def VT01
3
Mnemonic
TAPEMC
VT01
Sony Mch In
VC01 Sony Mch In
VC02
Sony Mch In
4
Group Name
VT01
VC01
VC02
TAPEMC MC−3000E Def VC01TAPEMC5
TAPEMC MC−3000E Def VC02TAPEMC6