Filter
Top Products
9. Starting up
9.1 Switching on the DP-1500 projector
Process:
1. Make sur e that the DP- 1500 projector is installed u pon a stable pedestal. See chapter "Positioning the DP-150 0 at port window ",
page 24.
2. Make s ure that the exhau st s ystem is properly installed. See chapter "Installation of the exhaust s ystem", page 27.
3. Make sure that the right lens is installed for your application. See chapter "Lenses & lens h older", pag e 33.
4. Make sure that the lamp and lamp house are correctly installed. See chapter "Lam p & lamp house", page 45.
5. Make s ure the projector is correctly connected to t he power net. See chapter "Electrical set up of the DP-1500", pag e 29.
6. Check if a video source is connected w ith the projector. See c hapter "S ource input ports of the DP-1500 pro jector", page 70.
7. Check if the communicator touch panel is installed. S ee chapter "Communicator touch panel", page 71.
8. Press the power switch to switch on the projector. As a result the projector s tarts up in standby. So, the lamp is off and the
dowser o pen. No internal pattern is selected. The communicator touch panel starts its initialization procedure..
- When ’0’ is visible, the projector is switched off.
- When ’1’ is visible, the projector is switched on.
9. Press the standby button on the local keypad or use the communicator touch panel to activate the lam p. As a result the applied
source will be displayed.
CAUTION: See user’s guide of the Communicator Touch Panel to operate and control the DP-1500 projector.
78 R59770091 DP-1500 06/01/2009