Filter
Top Products
4. Electrical set up of the DP-1500
4.1 Power requirements
Technical data
Power supply
Mono phase power net + PE (200-240VAC)
Frequency
50/60 Hz
Rated current 20 A
Lamp capacity 1500 to 3000 W
CAUTION: ALL POWER CONNECTIONS to the DP-1500 projector are made to the three-terminal strip located
in a sealed compartment behind the rear cover of the projector.
CAUTION: The cross-sectional area of the conductors in the Power Supply Cord shall be not less than 4 mm
2
or AWG 10
CAUTION: BECAUSE OF HIGH VOLTAGES impressed during the ignition cycle, the projector casing MUST
be grounded. Connect an adequate earth ground to the grounding lug adjacent to the terminal board
AC Requirements
THE A C REQUIREMENTS for the DP-1500 projector is a m ono phase system, with a separate ear th gr ound PE.
Voltage requirements are printed onto the Name and Data P late. The AC s upply must be installed by a qualified electrician in
conformance to local codes. Hardw are, wire sizes and c onduit types must comply with local codes.
A ge neral disconnect switch appropriate rated and readily ac cessible must be used to switch o ff the projector.
30
R59770091 DP-1500 06/01/2009