Filter
Top Products
3. Mechanical set up of the DP-1500
SCREEN CENTER SCREEN CENTER
OFF-CENTER
A B
Image 3-7
3. Proceed to leveling the projector by adjusting the feet of the projector as follows:
- Loosen the nuts (A), using a wrench of 17 mm, on the threaded rod.
- Adjust the height of the 3 legs (B) to level the projector, u sing a 14 mm wrench.
- Secure the leg height by tightening the nuts (A).
Note: There must be at least 5 cm between the bottom side of the projecto
r and the pedestal.
B
A
Image 3-8
4. Later, when the projector is up-and-running, adjust precise image geometry an d placement.
Projector tilting
In an ideal installation, the DP-1500 lens surface is centered with and parallel to the screen. This orientation helps to ensure
optimized lens performances with minimal offset. If this p osition is not pos sible (such as when the pr ojector is significantly higher
than the center of the screen), it is better to rely on offset rather than extra tilt.
1. Before adjusting tilt, make s ure the projector is as well-centered with the theatre screen as possible for your installation area.
2. Check with theatre personnel for th
e degree of s creen tilt, or m easur e this incline with a pr otractor at the sc reen.
3. Tilt the projector to closely match this screen tilt angle as follows:
- Loosen the nuts (A), using a wrench of 17 mm, on the threaded rod.
- Adjust the h eight of the legs until the projected im age matches the projection port window and the screen tilt.
- Secure the leg height by tightening the nuts (A).
R59770091 DP-1500 06/01/2009
25