Filter
Top Products
13. Removal and installation of projector covers
13.11 Installation of the side cover
Necessary tools
7mmflat screw driver.
How to install the side cover of the projector?
1. Check if the bottom and top filters are present.
2. Look through the small window, which is provided on the security cover of th e light processor and check the pressure indicated
on the internal manometer of the liquid cooling circuit. This pressure should be between 0,5 and 1 bar. If the pressure is out of
range, inform the responsible and qualified technician, so he m ay take necessary corrective action.
Image 13-21
3. Install the side cov er of the projector doing the following:
a) B ring the side cover towards its final position (A),
b) then gently push the locking studs of the top corners (B) into their receivers,
c) then gently push the locking studs of the bottom corners (C) into their receivers.
B
B
C
C
A
Image 13-22
4. Secure the side cover by locking the captive screw in the m iddle at t he bottom of the side cover.
Image 13-23
134 R59770091 DP-1500 06/01/2009