Filter
Top Products
3. Mechanical set up of the DP-1500
90°
4
Image 3-3
7. Slide the rear s ide over the edge of the pallet unit the two fixation sc rews (reference 5) at th e rear a re visible.
8. Remove the two hexagon socket head cap screw (reference 5). Use an 8 mm A llen wrench.
5
Image 3-4
9. Remove the projector from the wooden support plate and finally remove the 3 extension tubes (reference 6). Use a 17 mm
wrench.
6
6
Image 3-5
Save the original shipping carton a
nd packing material, they will be necessary if you ever have to ship your
projector. For maximum protection, repack your projector as it was originally packed at the factory.
A rubber foam inside a plastic bag is placed into the lens opening of the projector. It’s recommended to reuse
this foam and plastic back each time you transport the projector. This to prevent intrusion of dust and foreign
particles.
The lens is delivered in a separate box. For lens installation, see section “Lens & lens holder”.
R59770091 DP-1500 06/01/2009 23