2. Safety instructions
2.4 Heat and Fire Hazards
Warning Risk of Fire
Warning Risk of Fire: Do Not Place Flammable or Combustible M aterials Near Projector !
Barco large screen projection products are designed and manufactured to meet the most stringent safety regulations. This projector
radiates heat on its external surfaces and from ventilation duc ts during normal operation, which is both norm al and s afe. Exposing
flammable or combustible materials into close proximity of this projector could r esult in the spontaneous ignition of that material,
resulting in a fire. For this reason, it is absolutely neces sary to leave an “exclusion zone” around all external surfaces of the projector
whereby no flammable or combustible materials are present. The exclusion zone m ust be not less than 40 cm (16”) for all DLP
Cinema projectors. The exclusion zone on the lens side must be at least 5 m. Do not cover the projector o r the lens with any
material while the projector is in operation. Keep flammable and combustible materials away from the projector at all times. Mount
the projector in a well ventilated area away from sources of ignition and out of direct sun light. Never expose the projector to rain
or moisture. In the event of fir e, use sand, CO
2
, or dry powder fire ex tinguishers; nev er use water on an electrical fire. Always
have service performed on this projector by authorized Barco service personnel. A lways insist on genuine Barco replacement parts.
Never u se non-Barco replacem ent parts as they may degrade the safety of this projector.
Slots and Openings
Slots and openings in the cabinet and the sides are provided for ventilation; to en sure reliable operation o f the projector and to
protect it from ov erheating, these openings must not be blocked or c overed. The open
ings should never be blocked by placing the
product too close to walls, or other s imilar su rface. This product should nev er be placed near or over a radiator or heat register. This
projector should not b e placed in a built-in installation or enclosure unless proper v entilation is provided.
Projection Room
Projection rooms must be well ventilated or cooled in order to avoid build up of heat. It is necessary to vent hot exhaust air from
console to the outside of the building. T he minimum exhaus t airflow requirement is 6.65 m
3
/min or 235 CFM.
Replaceable Batteries
The projector electronic is provided with a replaceable battery.
CAUTION: Risk of explosion if battery is replaced by an incorrect type. For disposal of used batteries, always
consult federal, state, local and provincial hazardous waste disposal rules and regulations to ensure proper
disposal.
R59770091 DP-1500 06/01/2009 15