Filter
Top Products
3. Mechanical set up of the DP-1500
3.1 Unpacking the projector
What has to be done ?
At delivery the projector is packed in a carton box upon a wooden pallet and s ecured with banding and fastening clips. Furthermore,
to provide protection during transportation, the projector is surrounded with foam. Once the projector is arrived at the installation
site, it has to be removed from t he carton box and wooden pallet in a safe m anner without damaging the projector.
After unpacking let the projector acclimate to the room temperature which must be higher then 10°C (50°F)
and lower then 35°C (95°F). Neglecting this may result in a start up failure of the Light Processor Un
it.
Necessary tools
• 8 mm Allen wrench.
• 13 mm open end w rench.
• 17 mm open end w rench.
How to unpack the projector ?
1. Remove the banding around the carton box, by releas ing the fastening clips as illustrated, and open the box.
Image 3-1
2. Remove the smaller ca rton box (reference 1) as illustrated.
Note: The smaller carton box contains the manual.
1
2
3
Image 3-2
3. Remove the c arton box and the foam around the projector. See image 3-2.
Note: The projector is still attached to a wooden plate, which is secured the below pallet.
4. Loosen the four nuts ( reference 2 image 3-2) which secure the pallet a s illustrated. Use a 13 mm open end wrench.
5. Rotate the wooden support plate with projector 90° and slide the front side over the edge of the pallet until the fixation screw
(reference 4) is visible as illustrated.
6. Remove the hexagon socket head cap
screw(reference4).Usean8mmAllenwrench.
22
R59770091 DP-1500 06/01/2009