Filter
Top Products
13. Removal and installation of projector covers
13.3 Removal of the front cover
The input cover and the lens have to be removed before removing the front cover. See procedures "Removal
of the input cover", page 125, and "Lens removal", page 37.
Necessary tools
7mmflat screw driver.
How to remove the front cover of the projector?
1. Check if the input cover and the lens are rem oved.
2. Remove the rubber dust ring from the lens holder. See the d etail at the right side of image 13-5.
3. Release the c aptive screw at the middle bottom of the front c over, us ing a fl a t screw driver.
Image 13-5
4. Remove the front cover from the projector doing the following:
a) s tanding in front of the projector, pull the upp er right corner (A) of the front cover toward you until the latch releases,
b) pull the lower right corner (B) of the front cover toward you until the latch releases,
c) then move the front cover aw ay from the projector.
A
B
C
Image 13-6
126 R59770091 DP-1500 06/01/2009