Filter
Top Products
12. Servicing
12.3.2 Preparing for convergence adjustment
Necessary tools
Flat blade screwdriver 7x150.
How to set up the projector for convergence adjustment?
1. Remove all side co vers and top cover of the projector.
2. Open the sealed compartment of the Light Processor. See page 130.
3. Remove the convergence cover plate in the top plate as follow:
a) loos en both captive screws (reference 1).
b) s lide the c over plate forward until it becomes free from the top plate.
c) take off the cover plate.
1
Image 12-7
4. Reinstall the lens and start up the projector.
5. Use the Comm unicator software to activate the convergence test p attern.
4
1
2
5
3
6
Image 12-8
106 R59770091 DP-1500 06/01/2009