Filter
Top Products
3. Mechanical set up of the DP-1500
3.2 Positioning the DP-1500 at port window
WARNING: The installation of the DP-1500 projector requires at least 2 persons.
General guide lines
• Use a solid pe destal to put the DP-1500 projector on. Ensure that the pedestal can h andle the weight of
the projector and that
all feet of the projector are captured.
• The pedestal should be placed in front of the port window wall in this manner that the projector front cover is at a distance of
minimum 20 centimeter from the port window.
20 cm
Image 3-6
Barco offers a pedestal for the DP-1200 digital projector. This universal pedestal allows a solid and easy setup
of the projector. The universal pedestal has a separate compartment to install the UPS unit (if available) for
the DP-1200 digital projector. Futhermore, the universal pedestal contains a standard 19” rack to build in the
projector peripherals like alternative content switchers (e.g. ACS-2048).
Necessary tools
• 14 mm wr ench.
• 17 mm wr ench.
Projector centering
1. If the projector is standalone in front of the port window, center the projector with the theatre screen (see ref A image 3-7).
2. If a film projector is already pre sent (projector will be off-center), try to optimize aim (s ee ref B image 3-7).
Note: Unlike film projectors, it is best to keep the projector lens surface as parallel to the screen as possible, even if it is
significantly above the screen center.
The off-center position slightly increase side key stone, but will minimize horizontal lens offset required.
24
R59770091 DP-1500 06/01/2009