Filter
Top Products
Assembly Replacement ESG Family Signal Generators
Daughterboard Card Cage Boards
5-56 Service Guide
Daughterboard Card Cage Boards
Use this procedure to remove any of the following assemblies: (See Figure 5-35.)
• Output Board (A9)
• Reference Board (A11)
• Synthesizer/Doubler Board (A12)
• Sampler Board (A23)
• Frac-N/Divider Board (A24)
Tools Required
• T-8 TORX screwdriver
Removal
1. Remove the instrument cover. (Refer to the “Instrument Cover” replacement procedure
on page 5-64.)
2. Remove the right-side cover by removing the four screws that attach it to the
instrument chassis.
3. Simultaneously lift the left and right extractors (item 1) on the board you want to
remove.
4. Remove the board from the card cage slot.
Replacement
1. Reverse the removal procedure and torque all T-8 TORX screws to 9 in-lbs.