Filter
Top Products
Assembly Replacement ESG Family Signal Generators
A16 Line Module
5-32 Service Guide
A16 Line Module
Tools Required
• T-10 TORX screwdriver
• 5.5-mm wrench or nut driver
Removal
1. Remove the rear panel assembly. (Refer to the “Rear Panel” replacement procedure on
page 5-66 or, if you have Option 1EM, refer to the “Rear Panel (with Option 1EM)”
replacement procedure on page 5-70.)
2. Remove the nut (item 1 in Figure 5-17) that attaches the line module’s ground wire
(A16W2) to the inside of the rear panel.
3. Remove the two screws (item 2) that attach the line module (A16) to the rear panel.
4. Remove the line module from the opening in the rear panel.
Replacement
1. Reverse the removal procedure and do the following:
• Torque the 5.5-mm nut that attaches the ground wire to the rear panel to 9 in-lbs.
• Torque all T-10 TORX screws to 9 in-lbs.