Filter
Top Products
Replaceable Parts (ESG-AP and ESG-DP Series) ESG Family Signal Generators
Save Money with Rebuilt-Exchange Assemblies
4-4
Service Guide
Shipping the Defective Assembly Back to Agilent Technologies
1. When you receive the rebuilt assembly, be careful not to damage the box in which it was
shipped. You will use that box to return the defective assembly. The box you receive
should contain the following:
• the rebuilt assembly
• an exchange assembly failure report
• a return address label
2. Complete the failure report.
3. Place the failure report and the defective assembly in the box. Be sure to remove the
enclosed return address label.
4. Seal the box with tape.
If you are inside the United States, stick the preprinted return address label over the
label that is already on the box and return the box to Agilent Technologies.
(Agilent Technologies pays postage on boxes mailed within the United States.)
If you are outside the USA, do not use the return address label; instead, address the box
to the nearest Agilent Technologies sales and service office. (Refer to Table 1-1 on
page 1-9.)