Filter
Top Products
Advanced Use TANDBERG Director Videoconferencing System
90
Dataport configuration
The system provides two standard RS232 serial ports to
allow a computer to be connected for data transfer and
control purposes.
Dataport 1
If you wish to connect a PC to Dataport 1, you must ensure that the PC and the system are
identically configured. The available settings are:
Dataport 1 supports 4 different modes:
Data
Provides a transparent data channel. This channel can be used for many different purposes such
as file transfer, application sharing and more. When using this mode, it is necessary to have a
TANDBERG system at the far end.
Control
The control interface provided by the Dataport supports a subset of the Hayes command set as
well as a comprehensive set of system specific commands.
This mode maintains communication with the Dataport’s command interpreter at all times. All
features available from the hand-held remote control can be accessed through the dataport.
Modem
Allows you to control the system externally via a PC as in Control Mode. Once a call is established,
Dataport 1 will automatically switch to Data mode. When the call disconnects, Dataport 1 switches
back to Control Mode.
T.120
Provides a data channel supporting the T.120 standard for data communication. Using T.120
software on your PC, you can communicate with other T.120 systems using your PC and your
system.
NOTE
WHEN CONNECTING TO A PC THE
CONNECTING
CABLE MUST BE A
STRAIGHT
THROUGH RS232
CABLE.