Filter
Top Products
Installation TANDBERG Director Videoconferencing System
18
2. Remove the four caps and plugs from the mounting arm at the location where you want to
mount the shelf. Feed the cables for the videoconferencing camera through the large hole,
down the channel and through the lower mounting point.
3. If you’re installing the mounting arm on the same side as the IR receiver, detach the receiver
and leave it temporarily dangling. Carefully slide the mounting arm onto the side of the cabinet,
ensuring that the cables remain in the channel and are not pinched.
NOTE
CABLES SHOWN MAY NOT MATCH
THOSE
REQUIRED BY YOUR
VIDEOCONFERENCING CAMERA.