TANDBERG Director Videoconferencing System
5
• If you inadvertently smudge the rear surface of the interactive whiteboard, wipe it carefully
with a soft cloth and alcohol-free glass cleaner. Do not spray the glass cleaner directly onto
the surface; spray it lightly on the cloth, and then gently dab the rear surface of the interactive
whiteboard until the marks are removed.
• The 3000i uses digital cameras that are located inside the bezel. If you allow excess glass
cleaner to flow into the crack between the bezel and the writing surface, these cameras could
be damaged.
• Avoid setting up and using the Director in an area with excessive levels of dust, humidity and
cigarette smoke.
• Lock the casters after you set up the cabinet, so it remains stationary while in use.
• Avoid exposing the Director to extreme heat or cold. The operating temperature range is from
41 °F to 85 °F (5 °C to 29 °C) with up to 80% humidity (non-condensing). The shipping and
storage range is from -4 °F to 95 °F (-20 °C to 35 °C) with up to 80% humidity (non-condensing).
• Unplug the cabinet during electrical storms or if you won’t use it for an extended period of
time.
• This product is equipped with a three-wire grounding-type plug. This plug will only fit into a
grounding-type power outlet. If you are unable to insert the plug into the outlet, have your
electrician replace the obsolete outlet. Do not circumvent the safety features of the grounding-
type plug.
• Handle the power cord carefully and avoid excessive bending. Route the power cord so its
unlikely to be walked on or pinched by items placed upon or against it. Do not modify the
power cord.
• The socket outlet shall be installed near to the equipment and shall be easily accessible.
• Never do any installation of cables without first unplugging the Director’s power cord.
• Never install telephone jacks in wet locations unless the jack is specifically designed for wet
locations.
• Never touch uninstalled telephone wires or terminals unless the telephone line has been
disconnected at the network interface.
• Use caution when installing or modifying telephone lines.
• Avoid using a telephone (other than a cordless type) during an electrical storm. There may be a
remote risk of electrical shock from lightning.
• Do not use the telephone to report a gas leak in the vicinity of the leak.
• 1TR6 network type is not approved for connection directly to the telecommunications network.
This network type is only to be used behind a PABX.
• X.21 network type is not approved for connection directly to the telecommunications network.
This network type is only to be used together with already approved equipment, and is not
meant for direct connections to the telecommunication networks.
• V.35/RS-449/RS-366 network type is not approved for connection directly to the
telecommunications network. This network type is only to be used together with already
approved equipment, and is not intended for direct connection to the telecommunication
networks.
• Allow adequate air circulation to prevent internal heat build-up. Do not block any of the
ventilation openings of the apparatus.
• Do not install the system in a location near heat sources such as radiators or air ducts, or in a
place subject to direct sunlight, excessive dust, mechanical vibration or shock.