Filter
Top Products
AppendixTANDBERG Director Videoconferencing System
101
Appendix 5: Using the file system
It is possible to access a file system within the TANDBERG system by using FTP:
DOS-window ftp <IP-address of codec>
Web-browser ftp:// <IP-address of codec>
Description of the different files
all.prm all settings in the system (including directory)
dir.prm directory entries
event.log logs fault situations etc.
sw.pkg the system software
globdir.prm file containing up to 400 entries. These entries can not be edited from the
TANDBERG Videoconferencing system, but can be edited as a text-file.
Description of the different folders
user a folder to be used for custom logos etc.
remote a folder used for software upgrade of the far end TANDBERG system
What can be done by using the file system?
· software upgrade of the far end TANDBERG system (B3 or above) via ISDN
· upload of custom logos
Software upgrade
· Connect to the system you want to upgrade using ISDN.
· Copy the software file to a folder on your harddisk.
· Open a DOS-window and go to this folder.
· Type ftp <IP-address of your local codec).
· Enter password: <Release Key of far end system>
· Go to the remote folder, type “cd remote”
· Upload the software file, type put <s0xxxxxx.pkg>
· Wait until the following is shown:
226 Closing data connection.
5437569 bytes sent in 808.01 seconds (6.73 Kbytes/sec)
ftp>
· Restart the far end codec.
The far end system should now be upgraded. For further information, please contact your TANDBERG
representative.
Custom logos
· Go to the folder where your logo is located.
· Type ftp <IP-address of your local codec>.
· Go to the user folder, type “cd user”
· Upload the logo, type put <startup.jpg>
The new logo will be displayed the next time you restart your system.
NOTE
LOGO MAX SIZE: E1: 704X480,
B6: 320X200, FILE-FORMAT: JPG.
IF THE FILE IS TOO LARGE, NO
LOGO WILL BE DISPLAYED.