InstallationTANDBERG Director Videoconferencing System
27
Device Connections
Microphone
Connect the microphone cable to the XLR input of the 6000 codec. The default codec setting has
all microphone inputs enabled and the gain set to +3dB. Adjustments to the audio settings may be
done in ‘TOUCHSCREEN TOOLS’ or with the ‘IR CONTROLS’ (discussed later in this document).
Touch Panel
A 12” or 15” color video touch panel options are available for the Director system. Cables
necessary for connecting them to the system are included with the touch panel. See ‘BASIC
SYSTEM CONNECTIONS’ for details on connecting a touch panel. See APPENDIX 7: 12” TOUCH
PANEL INTERFACE.
Main Camera
The main camera source selection corresponds to the first s-video input (labeled “1”) on the codec.
This camera input used specifically with the controllable TANDBERG W.A.V.E II camera.
AUX Camera
The auxiliary camera source selection corresponds to the second s-video input (labeled “2”) on the
codec. This camera input can be a fixed room camera or can be a second controllable TANDBERG
W.A.V.E II camera. To control a second camera, control signaling must be “daisy-chained” from the
first camera. Additionally, the camera must be powered locally and the video must be run
separately back to the codec. Installation instructions for installing this are included with an extra
camera when purchased.
NOTE
IF CONNECTING TWO CAMERAS,
THEY MUST BE IDENTICAL - YOU
CANNOT
HAVE ONE WAVE II
CAMERA AND ONE SONY CAMERA.
THEY MUST BOTH BE WAVE II
CAMERAS OR BOTH BE A VISCA
CONTROLLABLE CAMERA OF THE
SAME MAKE AND MODEL.