Filter
Top Products
Advanced UseTANDBERG Director Videoconferencing System
65
Audio Outputs
Out3 is intended for connection to a VCR or other
recording equipment. The signal is a mix of audio from far
end and local end (not from Audio in 6).
Audio Module: Select Natural Audio Module (NAM or NAM
II) according to the type of Audio Module installed.
If an output is ‘Off’, no audio will be sent to that output.
Level Settings - Outputs
Out1 is intended for connection to TANDBERG Natural Audio, televisions or audio amplifiers.
Out2 is intended for connection to audio recording equipment or to a telephone add-on hybrid. The
signal is a mix of audio from both the far end and local end (not from Audio in 5).
Adjust the audio output levels according to the parameters of the external audio equipment
connected. These levels should only be adjusted when installing new audio equipment. The default
settings are correct for most consumer electronics devices (televisions, VCRs, etc.).
The volume buttons on the IR control adjust the level of output 1 (the speaker output). The volume
control has no effect on outputs 2 and 3.
NOTE
NEVER CONNECT AUDIO OUT 2 OR
AUDIO
OUT 3 TO A LOUDSPEAKER
PLACED
IN THE SAME ROOM AS
THE
MICROPHONES CONNECTED
TO
THE SYSTEM. DOING THIS WILL
CAUSE
“HOWLING” AND POSSIBLE
DAMAGE
TO THE SPEAKER
SYSTEM.