Filter
Top Products
General UseTANDBERG Director Videoconferencing System
41
Web-interface
It is possible to access and maintain the system remotely via a local area network (LAN) using a
standard Web-browser.
Connect your system from the LAN socket, found on the codec interface panel, to a local area
network. Then configure your codec:
• Press MENU, select ‘Terminal Settings’ > ‘LAN Settings’
• Specify IP-assignment ‘DHCP’ or ‘Static’. If DHCP is selected no other settings are needed.
If Static is selected, ‘IP-address’, ‘IP-subnet mask’ and ‘Gateway’ must be specified.
EXAMPLE:
IP-ASSIGNMENT:STATIC
IP-ADDRESS: 196.9.200.129
IP-SUBNET MASK: 255.255.255.0
GATEWAY: 196.9.200.21
See ‘ADVANCED USE’ > ‘LAN SETTINGS’ for further information.
• Start your Web-browser. In the address field type the IP-address of the codec. The Web-page
of the codec will be shown.
Text Chat / Closed Captioning
While in an ISDN or IP call to another system supporting Text Chat (T.140), select ‘Text Chat’ from
the Web-page of the codec. Enter text in the window displayed. When selecting ‘Send Text’, the
text will be displayed on the local and far-end monitor as shown below:
The local Text Chat window can be closed
manually from the Web-interface by pressing
‘Close Window’. It will also close
automatically after a few minutes without
activity.
Streaming
To view streaming, select ‘Streaming’ from the Web-
page of the codec. See separate ‘Streaming’ section
in this manual for further information.
PC SoftPresenter
PC SoftPresenter is used to display PC images on your system without using a VGA cable (PC
Presenter). The TANDBERG video conferencing system and your PC must be connected to a LAN. In
addition, VNC (Virtual Network Computing) server software must be installed on the PC.
To show the PC image:
NOTE
‘PC: VNC’ MUST BE SET IN
‘VIDEO SETTINGS’.
• Start the VNC software on your PC.
• Press PC on your remote control. Use UP/DOWN to
activate PAGE UP/PAGE DOWN on the PC.
For setup information and details, see ‘VNC SETTINGS’ in ‘ADVANCED USE’.
NOTE
THE SYSTEM MUST BE RESTARTED BEFORE
CHANGES
IN THE ‘LAN SETTINGS’ MENU CAN
TAKE
EFFECT. NOTICE THE ON-SCREEN
RESTART QUICK KEY OPTION.
NOTE
STREAMING CAN ONLY BE INITIATED ONLY IF IS
‘ON’.