InstallationTANDBERG Director Videoconferencing System
25
System Options
The SYSTEM OPTIONS button allows for limited modification of setup of the codec. Modification of
these setting from the default values may affect the operation of the Director system. The main
item of note is the ‘Camera Model’ setting. The system supports VISCA controlled cameras and
therefore is selectable between the W.A.V.E II and VISCA controlled cameras. VISCA cameras
would use the Aux 1 Output on the Director Rear Interface Panel.
Edit Directory
Allows the user to enter and edit directory entries for the Director system. First, update the
directory by following the instructions below. Then select the ‘Add New Entry’ button to add a new
directory entry, or select an existing directory entry to edit that information. Refer to
‘VIDEOCONFERENCE OPERATION’ > ‘EDITING SPEED DIAL DIRECTORY’ for more information.
Update Directory
Click UPDATE DIRECTORY to set the initial directory placeholders that will be negotiated between
the codec and control device for the Director system. Any time the codec directory is updated with
new or modified entries through any other method than using the EDIT DIRECTORY method
discussed above (i.e. Codec Data port, Web browser, Telnet, or TMS), the control device should be
“synchronized” with the updates made in the codec by clicking UPDATE DIRECTORY on the TOOLS
screen to have the latest modifications displayed.
NOTE
IF CONNECTING TWO CAMERAS,
THEY MUST BE IDENTICAL - YOU
CANNOT
HAVE ONE WAVE II
CAMERA AND ONE SONY CAMERA.
THEY MUST BOTH BE WAVE II
CAMERAS OR BOTH BE A VISCA
CONTROLLABLE CAMERA OF THE
SAME MAKE AND MODEL.