Filter
Top Products
Getting Started TANDBERG Director Videoconferencing System
34
General Codec Configuration
The control system communicates with the codec through Data 1 at 9600 baud, No parity bit, 8
data bits, and 1 stop bit. The codec should be left in its default configuration with the following
exceptions. Using the IR control, the following settings should be addressed:
• Enabled but unused ISDN lines (lines not active) should be disabled.
• Select the QUICK KEY ‘System Info’ (IR control) to view line status.
• To disable unused ISDN lines, press MENU on the remote control.
• Select the menu ‘Terminal Settings’ > ‘Network’ > ‘ISDN-BRI settings’.
• Select the relevant ‘Line Setup’ menu and set ‘Enabled: Off’.
• Enter System Name to identify the system during an MCU conference.
• Select ‘Utilities’ > ‘System Name’
• Enter the name using the NUMBER KEYS (as on a mobile phone).
• Select the language you want to use in ‘Terminal Settings’ > ‘Language’.
• If you are using two monitors, set ‘Utilities’ > ‘Dual Monitor: On’.
• To activate AES Encryption, MultiSite
TF
and/or Presenter, enter an option key (see
paperwork accompanying your system). See ‘Terminal Settings’ > ‘Software Options’.
• Press CONNECT on the IR control. A dial tone should be heard if the network is active.
• Using the monitor remote control, adjust the VOLUME on the monitor to a level of your choice.
This volume will be the default volume for all calls.
It is critical that the following settings are configured:
• All network and LAN information (SPIDS, IP Addresses, etc. )
• DuoVideo Mode “Manual”
NOTE
THESE SETTINGS ARE ESSENTIAL
FOR OPTIMAL SYSTEM SETUP.
TF - TANDBERG FIRST