Display OperationTANDBERG Videoconferencing System
43
Source Selection
Press a VIDEO SOURCE button to show its image in the display window. The User can change the
source selection at any time, the selected source button changes from blue to green when active.
Any device controls associated with that source will be displayed in the Video Display Window
after its selection.
Device Control
The Main and Aux sources can be positioned manually using the camera control buttons or by
using the presets.
Sends the Main source to the video display.
If this source has either the TANDBERG WAVE or Sony EVI
camera connected it can be controlled. See DEVICE
CONTROL.
Sends the Aux source to the video display.
If this source has either the TANDBERG WAVE or Sony EVI
camera connected it can be controlled. See DEVICE
CONTROL.
Sends the Document camera to the video display.
No device control are available for this source.
Sends the VCR or DVD to the video display.
No device control are available for this source.
Sends the PC to the video display.
If the Director module is installed within the Rear
Projection SMART Board 3000i and the PC is running the
SMART Board software, annotation and PC operation will
be possible.
M
AIN
AUX
DOC CAM
VCR / DVD
PC
Left and Right arrow buttons pan (move horizontally) the
camera image.
Up and Down arrow buttons tilt (move vertically) the
camera image.
Camera controls will be available for both Main and Aux
sources
Zooms in (enlarges the view of a participant).
Zoom out (reduces the view of a participant).
Moves and zooms either the Main or Aux camera to a
predefined room view.
To Store a preset: Move the camera to the view required.
Press and hold the PRESET button you want to set until the
red “preset stored” text appears.