Filter
Top Products
Advanced UseTANDBERG Director Videoconferencing System
87
Call Settings
SNMP Trap Host
SNMP (Simple Network Management Protocol) is used for monitoring and configuring of different
units in a network. The codec’s SNMP Agent responds to requests from SNMP Managers (a PC
program etc.). SNMP traps are generated by the agent to inform the manager about important
events.
SNMP Trap Host identifies the IP-address of the SNMP manager.
Traps can be sent to multiple SNMP Trap Hosts. Enter the IP address of up to three SNMP managers.
All traps will then be sent to the hosts listed.
SNMP Community
SNMP Community names are used to authenticate of SNMP requests. SNMP requests must have a
‘password’ in order to receive a response from the SNMP agent in the codec.
SNMP Settings
Incoming MCU calls
ON When you are in a call, the system will provide a visual/audio indication of an
incoming call and ask you to accept/reject the call.
OFF The system will not accept incoming calls when you are in a call.
NOTE
THE SNMP COMMUNITY NAME IS
CASE SENSITIVE.